Bartoline TX10 Paint Remover (500ml) - Effective & Non-Caustic

About this product: Hyper Tough paint and varnish remover is an extremely effective non-Methylene Chloride paint remover. The non-caustic formulation is simple and easy to use both indoors and outside. Instructions for use: PREPARATION. Read label fully before use. Wear protective gloves. Protect floor coverings, textile and vinyl materials. Shake container well before use. COVERAGE - 1 litre of Hyper Tough paint and varnish remover is sufficient to strip a surface area of approximately 1 square meter. APPLICATION - Pour a quantity of Hyper Tough paint and varnish remover into a suitable container. Apply a generous, thick even coat (do not brush out) at a rate of 1 litre per square meter, onto the surface to be stripped, with a suitable brush. Leave for approximately 1 hour and apply a second coat. For areas where there are less than 5 layers of paint or varnish, a second coat may not be necessary. Once the remover has softened the paint, scrape off, leaving surface as clean as possible. Repeat process if necessary. Rub down stripped area using a scrubbing brush or stainless steel pad (DO NOT USE WIRE WOOL). Wash down stripped area with clean spirit or detergent and water. Rinse with clean water and allow to dry. WARNING: Health & Safety - Contains: Benzyl alcohol. EC No. 202-859-9. Harmful if swallowed or if inhaled. Keep out of reach of children. Avoid breathing vapours. Do not eat, drink or smoke when using this product. Wash hands thoroughly after use. IF INHALED: Remove person to fresh air and keep comfortable for breathing. IF SWALLOWED: Call a doctor or NHS 111 if you feel unwell. Dispose of contents/container to hazardous waste collection point. To avoid the risk of spillage always ensure that the container is held upright during transportation and storage.